The heat source of the dryer machine comes from the combustion apparatus, and this dryer machine adopts concurrent heating manner. For this reason, the materials to be dried go into the cylinder from the feeding box or feeding chute and will be pushed back by the spiral shoveling plate. Due to the slant installation of the dryer machine, the materials inside it will flow to the trailing end under gravity and rotation of the cylinder, and on the other hand, the materials are repeatedly lifted by the shoveling plate to the upper end and then constantly scattered around, so that the materials will form an even curtain inside the cylinder to carry out full heat exchange with the hot air inside the cylinder. As the materials are scatter repeatedly, the water containing in them will be gradually dried, thus reaching the drying purpose.

Dryer machine, which can also be called drying machine or spray dryer, is mainly used for drying materials with some moisture and granularity in ore beneficiation, building material, metallurgy and chemical department. Rotary dryer has high adaptability to the materials so that it can be used for drying all kinds of materials, and in addition, the operation of this equipment is simple and reliable, for this reason, it get wide application.

Performance Features

Rotary dryers are mainly composed of rotary part, lifting board, transmission part, supporting part and seal ring. The rotary dryers produced by our company use new lifting board with many functions of guiding, current sharing and material lifting, and the materials can be comprehensively distributed on the radial sections of the dryer machine and the material curtain is in the thin, average and full state and the materials can fully contact the hot air, thus achieving the aim of making full use of the heat. The drum dryer produced by our company uses reasonable running parameters, and the coal and electricity consumption is reduced by over 10-15% and the output per machine is improved by over 10-15%, so that it has been widely used in the cement plants and ore beneficiation plants.

Working Principle

The heat source of the drying machine comes from the combustion device and this dryer uses co-current heating method, so that when the materials to be dried go into the cylinder from the feeding box or feeding chute, they are pushed back by the spiral lifting board. Since the spray machine is obliquely installed, the materials flow to the lower end of the machine under the gravity and the rotation of the machine, and on the other hand, the materials are repeatedly lifted by the lifting board to the higher end and then spread down constantly, so that the materials will form a even curtain inside the cylinder and conduct heat exchange with the hot air inside the cylinder. Since the materials constantly spread and the water contained in them will be dried, thus achieving the aim of drying.